|
Page 10.07
Tailcone |
|
Step 01:
Hook the J-stiffeners of the F-1281-L & R Lower Left and Right Skins
into the cutouts in the F-1208, F-1209 and F-1210 Frames. Cleco the
lower skins to the frames and F-1282-L & R Bottom Left and Right Skins.
Capture the F-1283A & B J-Stiffeners with the bottom lower left and
right skins
01/21/11
Builder Note: This step was preformed
on the work table and then moved to the assembly area work stands.
|
 |
Step 02: Place masking
tape over all of the holes that are within seven inches of the forward
edge of each tailcone skin. Those holes will be left open for the
remainder of this section
Builder Note: Cleco Used
Step 03: Rivet the
F-1282-L & R Bottom Left and Right Skins together. Rivet the F-1208,
F1209 and F1210 Frames to the bottom left and right skins. Rivet the
F-1281-L & R Lower Left and Right Skins only to the bottom left and
right skins, and the F-1283A & B J-Stiffeners using rivets called out in
Figure 1. Leave open all remaining holes in the lower left and right
skins.
01/21/11
ALTERATION
Rivets Used |
 |
|
|
