|
Page 10.05
Tailcone |
|
|
Step 01:
With the Stabilator Assembly on a workbench, check the fit of the F-1211
Assembly hinges with the Stabilator Assembly hinge brackets. Determine
the best symmetric choice of washers to minimize lateral play and
prevent binding throughout the stabilator travel. While determining the
hinge hardware, ues one washer between the bolt head and bracket, and
use only one washer on each side of the bearing. The called out
AN960-416 Washers may be substituted with AN960-416L Washers as
necessary. |
|
Step 02: Temporarily Super
glue the washers, determined in step 1, to the outboard side of the
HS-1213A inboard Hinge Bracket and the inboard side of the HS-1213B
Outboard Hinge Bracket. Be sparing with the super glue, contact only
washer and hinge bracket. Apply a minimal amount of oil to the bolt
shank, then locate the washers using the bolt called out in Figure 2.
Repeat this step for the remaining inboard hinge bracket. |
|
| |
|
| |
|
| |
|
